10
9. Remove the Resistance Knob (88) from a resis-
tance assembly.
Make sure that the 3/8" x 4
3/4" Bolt (90) stays inside of the resistance
assembly and that the resistance assembly
does not come apart.
Note: See the lower
drawing to reassemble the resistance assembly
if necessary.
Apply a small amount of the included grease
around the Resistance Cone (85) and the
Upright Insert (84).
Insert the Resistance Cone (85) into the Upright
Insert (84) in the Left Upright (77), with the two
large holes on top as shown. Then, tighten the
Resistance Knob (88) onto the 3/8" x 4 3/4" Bolt
(90).
Attach the other resistance assembly to the
Right Upright (92) in the same way.
88
Large
Holes
90
88
84
92
Large
Holes
85
90
77
10. Insert the end of a Crosswalk Arm (82) into the
hole in the top of a resistance assembly.
Make
sure that the bend in the Crosswalk Arm is
positioned as shown.
Tighten a #8 x 3/4" Screw (1) into the resistance
assembly and Crosswalk Arm (82) from the di-
rection shown. Press a Small Cap (89) into the
hole for the Screw.
Attach the other Crosswalk Arm (82) in the
same way.
Carefully lower the Crosswalk Arms (82) down
towards the Walking Belt (43).
82
1
Hole
89
1
82
89
43
10
Bend
Resistance
Assembly
Bend
Resistance
Assembly
9
85
84
