INSTALLATION
Power supply:
The TX-168PHB needs power to operate. Use the included power adaptor or
install 4x 1,5 Volt battery, size AAA.
Power adaptor: One power adaptor is included. Use this one or a version with the
following specifications:
input: 230 Volt, 50, Hz AC
output: 6 - 9 Volt DC, 200mA,
Batteries: open the battery compartment (direct below the handset) and install 4
pcs 1.5V AAA batteries. Mind the polarity. Batteries are not included.
Attention: always disconnect the telephone form the telephone outlet when
batteries are to be installed or replaced. See also page 11.
Telephonecord & handsetcord:
1.
connect the supplied handsetcord between the handset and base
2.
connect the telephonecord to the backside of the telephone; push the
connectors till you hear a click
3.
plug the telephone plug into your telephone outlet
Wall mount:
1.
drill two holes in the wall with a distance of 9cm and insert two screws; let
the heads of the screws stick out a few millimeters of the wall
2.
remove the handsetholder, rotate it 180° and replace it; this holder will hold
the handset when wall mounted
3.
hang the unit on the wall and fixate the telephone wire by means of
cable-clips
Once the power adaptor is plugged into a 230V mains outlet and / or the batte-
ries have been installed, the telephone is ready for use.
3
Summary of Contents for TX-168PHB
Page 1: ...USERS MANUAL TX 168PHB...
