Proflex TRX2 User Manual Download

Page: 12 / 14

TRX2 Elite Electric Treadmill

E&OE

Display shows "E07"

Safety tether not in place.

Place safety tether in correct location on console.

Equipment unsteady

Surface not flat.

Set-

up equipment on a flat surface. • If applicable,

rotate feet under front of machine to move up or
down as needed so equipment is steady.

When to Call for Help

This equipment is designed with user safety as a priority. In the event of electrical failure, the equipment will
shut off automatically to prevent injury and damage to the unit. If you encounter unusual behaviour from the
equipment, turn the power switch off and on to reset the equipment. This should ready the equipment for
normal operation again. If after you have reset the equipment that it is still not operational, call an authorized
service centre or technician for servicing.

Maintenance

Belt Lubrication

Lubricating the running belt helps maintain performance and
extends service life. Lubricate the belt after the first 25 hours of
use (or 2 to 3 months), then every 50 hours of use (or 5 to 8
months, or more frequently under extended usage).

To check if the belt requires lubrication, lift each side of it and
feel the top surface of the running deck. If the deck is slick to
the touch, no lubrication is required; if it is dry, lubricate. To
apply lubricant.

1. Lift the edge of the running belt so the running deck is exposed.

2. Place several drops of the supplied lubricant along the centre of the running deck.

3. Run the equipment at a slow speed for 3 to 5 minutes to evenly distribute lubricant.

Note

: Do not over lubricate. Wipe away any excess lubricant from the

running belt. • All-purpose household

oil or sewing machine oil can also be used.

Belt Alignment and Tension Adjustment

The running belt is pre-adjusted to the running deck at the factory, but after prolonged use it can stretch and
require re-tensioning. To adjust the belt, turn on the main power switch of the equipment and let the belt run
at a speed of 6km/h. Use the Allen key provided to turn the rear roller adjustment bolts to center the belt. If
the running belt is shifting to the left, turn the left adjustment bolt 1/4 turn to the right, and the running belt
should start to correct itself.

If the running belt is shifting to the right, then turn the right adjustment bolt 1/4 turn to the left, and the belt
should start to correct itself. Keep turning the adjustment bolts until the running belt is properly centered.

If the running belt is slipping during use, turn off and unplug the equipment. Using the Allen key provided,
turn both left and right rear roller adjustment bolts 1/4 turn to the right, then turn the main power switch back
on and run the equipment at a speed of 6km/h. Run on to the running belt to determine if the belt is still
slipping. Repeat this procedure until the belt no longer slips.

PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX PROFLEX