PROFIRE Inline Pilot Manual & Install Guide
Rev 1.0
PROFIRE
1.855.776.3473
[email protected]
Page 4 of 9
System Diagram
2.
Installation
The following steps provide instructions to complete the installation process. Please read the entire section and
follow the instructions carefully.
Important Safety Information
Fire or Explosion Hazard. Failure to properly ground the ILP back
to the Burner Management System’s Ion terminal
may result in accidental electrocution, product damage, or failure to ignite the pilot.
Check the maximum temperature for your installation and use suitable wiring for that application.
Connect the System
Connect the appropriate wires to the BMS terminals as described. Connect the gas line adapter fitting and gas line
to the source.
Please note: The Inline Pilot MUST be grounded to a suitable ground via the included grounding screw (green
screw) located on the rear of the Inline Pilot base hub.
