PF2100 4-20mA Input Card User Manual v1.2
©2021 Profire Energy Inc
June 2, 2021
Page 4
Quick Start Checklist
Follow these steps in order to install and setup the 4-20mA Card properly. Check off each
step after it is completed to ensure that you don’t miss a step. More
detailed information on how to complete each step is located in later sections of this document.
Preparation:
□
1.
Verify System Requirements
. See instructions on page 1.
□
2.
Verify Included Hardware
. See instructions on page 6.
□
3.
Verify DIP Switch Settings
. See instructions on page 13.
□
4.
Disconnect Power to Your PF2100 System
.
Install and Wiring:
□
5.
Install the 4-20mA Input Card in Your PF2100 System.
See instructions on page 6.
□
6.
Check the Required System Voltage for Your Transmitter.
See instructions on page 8.
□
7.
Wire up the “Level”
Current Loop.
See instructions on page 10.
□
□
8.
Wire up the
“Level”
Status Contacts, if Required.
See instructions on page 11.
9.
Wire up the “Pressure” Current Loop.
See instructions on page 12.
Menu Settings:
See instructions beginning on page 13.
□
10.
Enable the 4-20mA Input Card.
Use Menu 6.1.
□
11.
Select the Tank Volume Units.
Use Menu 6.2.
□
12.
Set the Tank’s Maximum Volume Level.
Use Menu 6.4.
□
□
□
□
13.
Set the Low and High “Level” Setpoints.
Use Menus 6.5 and 6.6.
14.
Set the Pressure Units.
Use Menu 6.7.
15.
Set the Maximum Pressure of the Fuel Train.
Use Menu 6.8.
16.
Set the Low and High “Pressure” Setpoints.
Use Menus 6.9 and 6.10.
Calibration:
□
17.
Ensure that the Level Transmitter is Calibrated Correctly.
See instructions beginning on page 15.
□
18.
Calibrate the “Level” input’s
zero point.
See instructions beginning on page 15.
□
19.
Calibrate the “Level” input’s span
(max point).
See instructions beginning on page 16.
□
20.
Calibrate the “Pressure” input’s zero point.
See instructions beginning on page 16.
□
21.
Calibrate the “Pressure” input’s span (max point).
See instructions beginning on page 16.
