Profile 423000078, Manual

Page: 15 / 34

SET A TEMPERATURE CORRECTION
If you use the thermostat head in combination with a wall thermostat, then the wall thermostat determines the
room temperature. It is thus possible that it is colder or warmer elsewhere in the room. To compensate for this,
a temperature variance can be set.
For example: when your wall thermostat measures 22 degrees and the smart thermostat head measures 24
degrees, then you can adjust the thermostat head by 2 degrees.
Proceed as follows:
- Keep the Menu button pressed until ‘Pro’ appears on the display.
- Choose ‘tOF’ by turning the dial button.
- Press the OK button.
- ‘0.0 °C’ appears on the display.
- Set the preferred offset temperature by turning the dial button.
- Press OK to confirm.
OPERATING THE HEATING CONTROL SET WITH REMOTE CONTROL
Using the remote control the heating can be set to a high or low temperature. To this end, the thermostat head
needs first to be set on a high and low temperature.
Setting a high or a low temperature
Notice!
The thermostat head can be connected to up to 3 wireless devices (such as a Qnect Smart plug, a remote
control or a sensor). When the memory is full, (FULL) appears on the display.
- Keep the Menu button pressed until ‘Pro’ appears on the display.
- Choose ‘rFS’ by turning the dial button.
Notice!
Make sure that you choose ‘rFS’ and not ‘rES’. When you chose ‘rES’ and follow the steps below, you reset the
smart thermostat head to the factory settings.
- Press the OK button. The thermostat head arrives in the coupling position. Within 30 seconds a remote control
can be coupled or decoupled. Perform one of the following actions:
- Press one of the ON(HIGH) buttons to couple the remote control. When a beep sounds, the remote control has
been coupled. Press one of the OFF(LOW) buttons to decouple the remote control. When a beep sounds, the
remote control has been decoupled.
Operate the thermostat head with a remote control
Set the preferred smart thermostat head to a high and low temperature. Perform one of the following actions:
- Press the ON (HIGH) button to connect the thermostat head to the high adjusted temperature.
- Press the OFF (LOW) button to connect the thermostat head to the low adjusted temperature.
Disconnect all remote control devices via the thermostat head
- Keep the Menu button pressed until ‘Pro’ appears on the display.
- Choose ‘UnL’ by turning the dial button.
- Press the OK button. ‘UnL’ flashes on the display.
- Press OK to disconnect all paired remote control devices. Press the Menu button to cancel.
EN