Profibus IQ plus 800, Installation And Programming Manual

Page: 16 / 22

12 Profibus Indicator Interface Installation and Programming Manual
3.2.1 Floating Point Commands
Table 3-6 lists the ßoating point commands that can be speciÞed for IQ plus 800/810 and IQ plus 310A
indicators. Valid commands for each indicator are indicated by a check mark (
Ö
). The number representing the
indicator command is sent in word 0 (bits 0Ð8).
3.3 Status Data
Table 3-7 shows the remote function status data format; Table 3-8 shows the batch status data format. The batch
status format is used in response to command 42 (hex 2A), Batch Status.
Hex Decimal Command 800/810 310A
101 257 Set Tare
Ö Ö
102 258 Read Tare
Ö Ö
103 259 Read Accumulator
Ö
104 260 Read Gross
Ö Ö
105 261 Read Net
Ö Ö
106 262 Set Setpoint Value
Ö
107 263 Set Setpoint Hysteresis
Ö
108 264 Set Setpoint Bandwidth
Ö
109 265 Set Setpoint Preact
Ö
10A 266 Read Setpoint Value
Ö
10B 267 Read Setpoint Hysteresis
Ö
10C 268 Read Setpoint Bandwidth
Ö
10D 269 Read Setpoint Preact
Ö
10E 270 Set Batching State
Ö
Table 3-6. IQ plus 800/810 and IQ plus 310A Floating Point Commands
Bit
Status Data
Value=0 Value=1
s00 No Error Error
s01 Tare not entered Tare entered
s02 Not zero Center of zero
s03 Weight OK Weight invalid
s04 Standstill In motion
s05 Primary units Secondary units
s06 Tare not acquired Tare acquired
s07 Gross weight Net weight
s08 Channel 0 or 1 Channel 2, 3, or 4
s09 Not used
s10
s11 Positive weight Negative weight
s12 Not used
s13
s14
s15
Table 3-7. Run Status Word Format
Bit
Status Data
Value=0 Value=1
s00 No Error Error
s01 DIGIN 3 = OFF DIGIN 3 = ON
s02 DIGIN 2 = OFF DIGIN 2 = ON
s03 DIGIN 1 = OFF DIGIN 1 = ON
s04 Batch paused Batch not paused
s05 Batch running Batch not running
s06 Batch not stopped Batch stopped
s07 Not used
s08
s09
s10
s11
s12
s13
s14
s15
Table 3-8. Batch Status Word Format
DISCONTINUED