Profi-pumpe FELS-SCHALEN, Operating Instructions Manual

Page: 3 / 18

English 3
3. ASSEMBLY INSTRUCTIONS
z
Unpack all the water fountain components from
the packaging and lie on a flat surface.
z
Connect the pump to the rubber tube. Make sure
the tube is properly connected and is not kinked.
z
Connect led (preassembly to fountain body) to
cable connector one by one.
z
Connect cable connector to female cord from
pump body.
z
Install fountain top on the base, ensure it is stable
before continuing.
z
Connect pump cord to adapter.
z
Fill clean water to the reservoir. Note: Destilled
water is recomended to reduce mineral deposits
and bacteria build-up.
z
Insert the plug into the power socket. If installed
correctly water will start to flow from the feature.
z
Mount the solar panel (see illustration). Remove
the protective film from the solar panel (if any) .
z
Position the solar panel so that it receives direct
sunlight. The Li-ion battery can only work if the
solar cell is not shaded. Adjust the solar panel
angle to maxinlise the amount of solar energy
collected.
z
Connect the pump on the panel (see illustration).
Check whether the flow is fully open (or else
promoted little or no water).
Please note, due to the shape of the slate, some water splashing out of the fountain
is inevitable in the first few seconds.
LED
Solar panel
Pump
Water-
hose
Cabel
connector
Summer:
0°- 30°
Spring/Autunm:
30°- 60°
Fill the fountain with water.
The pump must be completely submer-
ged in water, otherwise the pump will be
damaged.
LED-
cabel Power
cable
Water-
hose
When all connections are
complete, place the pump at
the bottom of the fountain.
Route the power cable to the
outside.