PROF DC 16E, Instruction Manual

Page: 9 / 118

7
means 30% ≤ambient room humidity < 50% or 70% < ambient room
humidity ≤80%
means the ambient room humidity is higher than 80%.
3. compressor is in progress. In case the de-frost function is working, the
water drops will flash.
compressor is not in progress.
water full.
4.
Heat indicator (only for the model with heat function): While you press the
heat button and the ambient temperature is lower than 25
o C, the heat indicator
will light on and the heater will work. At this time, the fan speed will keep at
high speed only. However, if the ambient temperature is higher than 25
o C, the
heat indicator will not light on and the heater will not work, either.
* This PTC
heater is protected by thermostat & thermal fuse for overheat protection.
5. UV ( ultraviolet ) indicator, only for the model with UV light. * UV can kill the
bacteria in the air.
6. Timer indicator, 1 to 24 hours.
7. Room humidity indicator, can display the room temperature in Celsius degree
(
o
C) or Fahrenheit (depending on the version you purchased) by pressing
“HUM” button for at least 2 seconds.
8. Fan speed/ventilation indicator: high speed, low speed.
Operation
1.
Plug the unit into a correct mains socket. (Please refer to the rating label at the
rear of the unit.)
2. Press button ON/OFF to turn on the unit. The compressor will start to work in
continuous mode.
3. Press button HUMIDITY to set the room humidity you need: continuous
de-humidifying , 50%, 60%, 70% or 80%
4. Press the speed button to choose the ventilation speed, high or low.
5. To turn off the unit, press button ON/OFF again.
6. The direction of the air outlet can be adjusted by hand.