7
WM11M HANDHELD TRANSMITTER
See FIG. 2 at page 16:
1.
MICROPHONE GRID
The grid protects the microphone capsule and include a pop filter. Type of microphone capsule is
dynamic with a cardioid unidirectional figure.
2.
BATT
Red LED that shows the battery status:
•
When the microphone is switched on, the red led will light for about 1 second.
•
If the batteries are good, it will turn off (even if the microphone is switched on and operative).
•
The led will light again if the microphone is switched on and the batteries are near to be exhaust, to
indicate that they must be replaced as soon as possible.
3.
ON / MUTE / OFF
On/off switch, downward the microphone is off, upward the microphone is on. There is a middle position
where the microphone is on but it is muted, useful in case you don’t want to hear the typical switching
on/off click.
4.
BATTERIES COVER
Sliding down the lower part of the microphone body you can access to the battery inlet.
5.
BATTERIES INLET
To operate the microphone needs 2 type AA alkaline batteries.
Note: the microphone is able to operate also with 2 Ni-MH rechargeable batteries, but in this case the
operating time is less.
6.
FREQUENCY
On the back side of the batteries inlet an adhesive shows the operating frequency of the transmitter.
(The figure shows some optional accessories available from the PROEL catalogue.)
WM11B BODYPACK TRANSMITTER
See FIG. 3 at page 17:
1.
INPUT
TA3M mini XLR input socket to connect the supplied microphones.
2.
LOW BAT
Red LED that shows the battery status:
•
When the microphone is switched on the red led will light for about 1 second.
•
If the batteries are good, it will turn off (even if the microphone is switched on and operative).
•
The led will light again if the microphone is switched on and the batteries are near to be exhaust, to
indicate that they must be replaced as soon as possible.
3.
OFF ON
On/off switch, fully at left the microphone is on, fully at right the microphone is off.
4.
ANTENNA
This is the transmitting integral antenna: do not force, try to disconnect, or replace with other one.
5.
BATTERIES COVER
Sliding down the lower part of the bodypack you can access to the battery inlet.
6.
BATTERIES INLET
To operate the microphone needs 2 type AA alkaline batteries.
Note: the microphone is able to operate also with 2 Ni-MH rechargeable batteries, but in this case the
operating time is less.
