9
MAIN GUIDELINES
-
Warning! This product is not for household use.
-
Read this manual before powering or installing the fixture, follow the safety precautions listed below
and observe all warnings in this manual and printed on the fixture. If you have questions about how
to operate the fixture safely, please contact a PROEL distributor for assistance. Refer any service
operation not described in this manual to a qualified technician.
-
Do not modify the fixture or install other than genuine PROEL accessories and upgrade kits.
-
Refer servicing to qualified personnel.
-
Maximum ambient temperature T
a
= 40°C.
-
See serial label for replacement fuse size and lamp type.
-
Suitable for mounting on normally flammable surfaces.
-
Do not look directly into the laser.
-
Risk of fire, electrical shock and burns.
-
Use only in dry locations.
-
For indoors use only.
-
Do NOT block exhaust vents.
-
If the external power cord of this luminaire is damaged, it shall be replaced by a special cord
exclusively available from your PROEL dealer.
-
Warning always disconnect from mains power before replacing the fuses, or any part, and when not
in use.
-
Before operation ensure that factory setting of voltage and frequency match local power supply.
-
Always ground (earth) the fixture electrically.
-
Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault protection.
-
Do not expose the fixture to rain or moisture.
-
Never operate the fixture with missing or damaged lenses and/or covers.
-
Minimum distance to flammable material = 1 m.
-
Minimum distance to illuminated surface = 2.5 m.
-
Never attempt to bypass the thermostatic switch or fuses. Always replace defective fuses with ones
of the specified type and rating.
-
Ensure that the air flow through vents is free and unobstructed.
-
Provide a minimum clearance of 0.1 meters around air vents.
-
Never place filters or other materials over the lens or in the optical path.
-
Do not operate the fixture if the ambient temperature (T
a
) exceeds 40° C.
-
Do not stare directly into the laser.
