REAR PANEL DESCRIPTION
fig.2
1) XLR & 6.3mm. (1/4” TRS) jack, balanced linked inputs.
2) 30Hz sub-sonic filter.
3) CLIP LIMITER circuit on/off switch.
4) AMP MODE selector:
MONO
– Input A only is active and its signal is routed to both
amplifier stages. The level control of channel A sets the output
level for CHANNEL A & CHANNEL B Speakon outputs.
STEREO
- Two independent amplification paths, input A is output
on CHANNEL A Speakon, while input B is output on CHANNEL B
Speakon.
BRIDGED
- Input A only is active and its signal is routed to both
amplifier stages, linked in a “bridged” way (in order to supply more
power, the powered signal of both amplification section is
summed). The level control of channel A sets the output level for
BRIDGED Speakon output.
5) Three Speak-on output connectors for CHANNEL A, CHANNEL B
and BRIDGED. Please note that BRIDGED output must be used with
AMP MODE BRIDGED selection only, while CHANNEL A and
CHANNEL B outputs should be used both in MONO mode both
STEREO mode.
6) BREAKER circuit reset switch is available only in the 220VAC
version.
115 VAC version traditional fuse.
Summary of Contents for APW1000
Page 1: ...INSTRUCTION MANUAL APW1000 2000 3000 Power Amplifiers...
Page 11: ...Notes...
