Prodys S.L. Tel: +34 91 6896880
Fax: +34 91 6943777
Email:
Web:
www.prodys.com
Page 52
By default all the switches must be in OFF position according the picture. The
inverted view is according the codec position on the previous picture.
Switch number 7 will restore the default
factory configuration
if
set ON before a power cycle.
The IP address is changed to a DHCP IP configuration. In case a
DHCP server is not available on the network the address is set to
192.168.100.100 and the netmask to 255.255.255.0.
After the factory default setting the switch number 7 must return to the OFF
position for usual operation.
VI.2
Optional battery installation
An optional battery can be attached to the Quantum W. The battery not only
allows independence for portable applications, but also redundancy if the main
power can not avoid large voltage dips; since the codec operates continuously
without care of those impairments.
The battery is attached on the bottom side of the Quantum W unit. Following
procedure is indicated for installation:
1.
Switch OFF the unit.
2.
Look for the battery connector at the bottom panel of the unit.
3.
Place the battery, checking that no room is between codec and battery
surfaces. The battery has to dock on the proper bottom connector. (see
picture below)
4.
Fix the battery on each corner with the screws supplied with the battery.
5.
Switch ON the unit. The unit should be able to boot without the main
power cord connected.
ON
OFF
