p.6
SYSTEMS INSTALLATION
Blower must be installed under the floor or in a nearby cabinet.
A minimum space of 2" around the blower is necessary so that the air can be renewed constantly and
thus allow air circulation with the ambient air.
During automatic purge, the blower automatically starts a purge of about 1 minute and a
half, 20 minutes after the blower is off.
SYSTEMS CONNECTION
The electrical connections must be done by a licensed electrician to ensure that your installation is safe
and complies with the applicable building code in your area.
Your system must be connected to an independant 110/120 volt circuit, protected by a class A ground
fault circuit interupter.
*In Canada only: Each electronic component must be connected to the electrical panel by a junction box,
refer to your local electrical code.
RECEIVER MODULE INSTALLATION
System only activates using the remote control.
1.
Plug in the cable as show on the drawing.
2.
Once it’s connected, the remote control is ready for synchronisation.
SYNCHRONIZATION
1.
Once the system has been connected, the remote control must be synchronized with its receiver
module.
2.
Switch off the main breaker or unplug the system and switch it on again.
*From this moment, you have 15 secondes to proceed with the synchonization.
3.
Press simultaneously on the buttons 2 and 3 of the remote for 4 seconds.
The remote contol is now synchronized and ready to use. If the synchronization is not successful the first
time,you should resynchronize, starting at Step 2.
The remote control :
- Is completely sealed and waterproof.
- Floats.
- Responds within 15 feet.
- Is equipped with extra long batteries.
IMPORTANT
In order to obtain the best reception, we recommend to not install the receiver module next to the faucets
or metal piping.
Location of the receiver module must be easily accessible from the outside of the bathtub for mainte-
nance.
