Proctor PCAM-5580, User Manual

Page: 37 / 55

Megapixel IP Camera Manual
www.proctorsystems.com
37/55
When a decoder instead of a PC client is connected to an IP camera, one system becomes a Local system
and the other a Remote system (Generally a system which is being used by the user is called as Local
system). Then, actions for events can be configured for events from the remote system as well as for local
system. For example, it is possible to turn on an alarm device in local (center) decoder system when a sensor
device in remote (site) IP camera is triggered.
Local section configures the actions for events from local (self)
system, and configuration activates local devices and Remote sections configure the actions for events from
remote (peer) system.
The following table lists the possible actions for events.
Action Description
Alarm out Triggers alarm (relay) port.
E-mail
Sends E-mail to the specified address. AVI
file can be attached
FTP Upload AVI file to a specified FTP server
Preset Move to the Preset position
Local & Remote Event Configuration
l
Sensor
Configure the actions when the sensor is activated. Multiple actions can be set for a single event.
l
On Video Loss
Configure the actions when video input signal is lost. Multiple actions can be set for a single event.
l
On Motion
Configure the actions when motion is detected. Multiple actions can be set for a single event.
On Disconnect
Configure the actions when the link (connection) with peer system is disconnected. Multiple actions can be set
for a single event.
Duration
Set the duration of alarm or beep activation in case of an event. If it is set to continuous, it will be in active
state until an operator reset it manually.