Proctor PCAM-5580, User Manual

Page: 30 / 55

Megapixel IP Camera Manual
www.proctorsystems.com
30/55
l
MPEG-TS is a standard format for transmission and storage of audio, video, and data,[7] and is used in
broadcast systems such as DVB and ATSC. Transport Stream is specified in MPEG-2 Part 1, Systems
(formally known as ISO/IEC standard 13818-1 or ITU-T Rec. H.222.0). Transport stream specifies a
container format encapsulating packetized elementary streams, with error correction and stream
synchronization features for maintaining transmission integrity when the signal is degraded.
As MPEG-TS itself supports only AAC as the audio algorithm, only video is streamed when audio
algorithm is set to G.711.
Related settings are as follows:
- Destination IP : Set the IP Address of the destination system which will receive MPEG-TS stream
- Destination Port : Set the Port of the destination system which will receive MPEG-TS stream
SNMP
Setup for using SNMP (Simple Network Management Protocol). It is compatible to both SNMPv1
and SNMPvec. Settings for using SNMP (Simple Network Management Protocol) are as following
l
SNMP Listen Port(0, 161, 1025 ~ 65535): The port is for connecting external devices when system
operates as a SNMP client. SNMP is not used by setting 0 value.
l
SNMP Trap Destination IP : Set the SNMP Trap Destination IP.
l
SNMP Trap Destination Port (0, 162, 1025 ~ 65535): Set the SNMP Trap Destination Port. SNMP is not
used by setting 0 value.
Multicast
l
Multicast IP
The Multicast menu is used for configuring the multicast IP address to which media stream is delivered
when a client such as a Decoder, VMS or NVR software is connected in multicast mode. The multicast IP
address selection range is between 224.0.0.0 and 239.255.255.255. The selection can be used only
when media protocol is set to Multicast.
Simple Network Management Protocol (SNMP) is used by network management systems to
communicate with network elements. SNMP lets TCP/IP-based network management clients use a
TCP/IP-based internetwork to exchange information about the configuration and status of nodes.
SNMP can also generate trap messages used to report significant TCP/IP events asynchronously to
interested clients. For example, a router could send a message if one of its redundant power supplies