5
5.
Repeat with remaining screws.
Place electrical cord through
slot on back of can opener.
Slide can opener into place
from back of bracket. Slide
forward until it snaps into place.
NOTE:
Based on the variety of
cabinet sizes, the enclosed screws
for mounting may not work. Longer or shorter screws may
be purchased at your local hardware store.
1.
Plug cord into 120 volt AC outlet.
2.
Raise piercing lever and magnet.
3.
Tilt top of can toward can opener, to position cutting
blade inside rim of can.
4.
Lower the piercing lever and magnet. This starts the
cutting action. The lever will remain down until lid is
completely cut. Then the can opener will stop
automatically.
5.
Hold the can and then raise piercing lever to release
the can.
6.
Carefully slide the lid away from the magnet.
Using Your Can Opener
4
1.
This can opener is designed to be installed under a
cabinet. When selecting a location for installation,
please consider the following:
• An electrical outlet should be within easy reach of
the cord so that the cord does not drape over heating
appliances or get in the way of your normal work
space.
• Do not install the can opener above a cooking or
heating unit, such as a stove, or above a sink or basin.
2.
Position the mounting bracket
on underside of cabinet, at
least 4 inches from wall, and
1 inch from front of cabinet
edge. Use a sharp nail or ice
pick through bracket holes to
mark cabinet for drilling holes.
3.
Drill holes through cabinet.
4.
Place mounting bracket on
under side of cabinet. Hold
nut in screw hole with finger.
Insert screw from inside
cabinet and tighten with
screwdriver.
Installation
