EN|ENGLISH
5
BEFORE START
Unpacking
Carefully unpack the instrument and the necessary parts. Retain the
packaging for future storage. Remove the remaining packages of moving
parts (if any).
GETTING STARTED
Before you start, be sure to check that the mains voltage and power values,
being on the technical label on the unit.
Be sure to install protective screens and reference sites. Securely attached
and check the lock before each start.
This grinder has in its design a high power motor that when you start to
consume a lot of current (inrush current). Verify the ability to connect to your
high-power electrical appliances electricity (consult the appropriate service).
If the tool is used in winter, it is necessary to sustain power at room
temperature for 2 hours at a temperature not lower 18-
20 C°. In the case of
condensation, power tools include smoking, until it is completely dry.
SWITCH ON (ON)
Gently press on the Power button (ON / OFF) to turn on the power tool. See
figure describing the details of the power tool. Perform the required
operation.
NOTE
Models with soft start function, gradually gaining momentum, the work in
this case should begin only after the motor is completely dispersed and reach
full operating speed.
During operation, it is necessary to follow the work tool. Remember careless
handling of the power tool may result in injury to the operator.
TURNING OFF (OFF)
To turn off the tool and stop the execution of the power key (ON / OFF). See
figure describing the details of electronic instruments.
WARNING!
During operation, prevents jamming moving parts. To compare with the
required level of work capacity of the power tool. Wedging can damage the
tool.
PROCESS OF OPERATING A POWER TOOL
Power tool designed for easy and safe operation, but in the process it is
necessary to observe the following rules.
Before you start, make a trial without turning the power load to ensure
correct operation of the tool.
