»
INSTALLATION INSTRUCTIONS
/ OCTO & OCTO+
proswell.fr
Screw the multi- directional eyeball assembly into the return fitting
body. The eyeball should be pointed left to facilitate the flow of
water necessary for efficient filtration.
(Prior to assembly, apply a layer of silicon grease to the eyeball and
its housing to facilitate its movement and subsequent removal).
56
Glue the second skimmer gasket to the interior surface of the skimmer or filtration unit flange.
Locate the 4 corner holes of the mouth and mark them with a pen.
Position the flange such that its corner holes are aligned with the points marked in pen.
Use a small screw driver or punch to pierce the liner at the 4 points marked and fix the flange in position with the gasket
against the liner. Once the 4 corner screws are in place, continue, inserting a screw through each hole. Avoid over
tightening, this could deform the flange. Tighten the screws alternately to ensure an even and leaktight fit.
Cut away the liner inside the flange. Keep the off-
cuts for future repairs.
In the case of skimmers, clip the weir into place,
smooth surface facing the pool. The weir should be
able to swing freely.
Mount the skimmer face plate.
The skimmer basket is passed through the skimmer
mouth, swing the weir towards the pool to make
space.
Place the lid on the skimmer.
(these parts can be found in the Pool Fitting skin
pack)
In the case of a filtration unit, refer to the installation
instructions enclosed with the unit.
57
58
59
17
