23/32
2009/10 - Indice de révision : I - Code : 0035001
Carry out the following connections:
1 - connect the motor cable quick fit connector to the connecting box.
2 - connect the battery cable quick fit connector to the connecting box.
The design of these two connectors is different to prevent any
accidental inversion of the connections.
FINISH
Take the two sets of keys out of the bag that contained the notice.
Before closing the lid, insert the key and turn. Make sure that the electrical
cables are not caught between the connecting box and the lid. Press the button
closest to the pool. Observe rotation of the axle.The axle should turn as though
to roll the cover out over the pool (see the direction of movement on page 8).
If this is not the case, swap the two FASTON lugs in the connecting box
and try again.
1
2
Possible
inversion of the
connectors
Clean out the holes and drive the express studs M10x125 in using the hard rubber hammer. take care to protect the stud's
upper threading and nut. Use the nut to tighten the stand against the ground.
10
11
12
13
SOLAR OR BATTERY VERSION:
MOTORISED VERSION