8
PLG029b
EN
G
LI
S
H
2. With the line head or steel blade removed, place the brush cutter guard on the
gear head as shown in fig.5.
3. Using the included T25 torx driver wrench or a slot screwdriver, re-install the
three M6 x 15 torx/slot pan head screws from bottom through the guard and
into the gear head (fig.6).
4. Tighten the screws securely.
Installing the brush cutter blade
1. Be sure the safety guard for the brush cutter blade is properly installed.
WARNING!
Do not install the brush cutter blade without first attaching the guard.
2. Place the machine upside-down (with the cutting head facing up) on a horizontal
surface.
3. Place the spacer sleeve (Q, fig. 4) over the gear head shaft (fig.7).
4. Place the blade seat flange (R, fig. 4) over the gear head shaft (fig.8), aligning
grooves in the flange with the splines on the shaft.
aSSEMBLy
Summary of Contents for PLG029
Page 41: ...v 080131 41 FRANÇAIS ENGLISH 4 Schematic Drawing Schéma ...
Page 42: ...42 PLG029b ENGLISH FRANÇAIS NOTES ...
Page 43: ...v 080131 43 FRANÇAIS ENGLISH NOTES ...
Page 44: ......
