H - I - J
PROGRAMMER’S MANUAL
V8.94.11-
- 70 -
Variable system parameters
Submenu
Explanation, further submenus
Values
Default setting
Unit
11-5
remote control
Settings needed for the remote control of the equipment. Equipments connected to the same bus
must have different identifiers, but identical data transmission rates!
11-5-1 identifier
1 - 16
1
11-5-2 baudrate
Data transfer rate
9k6Baud
19k2Baud
38k4Baud
38k4Baud
11-5-3 mode
Communication mode of the MOD bus
ASCII
RTU
ASCII
11-5-6 parity
Communication parity bit of the MOD bus
no
even
odd
even
11-6
modulation
Setting of the parameters connected with the PWM output voltage.
11-6-1 carrier frequency
This menu item sets the switching frequency of
the frequency converter end stage.
2000 - 15000
8000
Hz
11-6-2 type
* flat-top in case of VLD and VHD types only
symmetric
mixed
flat-top *
symmetric
11-6-3 changing frequency
Setting the switch-over frequency is necessary at
mixed The modulation. is symmetrical below and
flat-top type above.
type-dep. - 500,0 type-dependent
Hz
11-6-4 dead time compensation
none:
Compensation switched off.
software: Estimated
compensation
of
the
threshold voltage of the diode and the
IGBT, and the switch-over times.
hardware: The equipment measures back the
place of the switch-over and the
compensation will be made based on
this. This is to be used in signal
transmitter or in vector mode in order to
accurately establish the voltage getting
on the motor.
none
software
hardware
software
11-7
slip-
compensation
This item permits the automatic modification of the motor frequency so that the rotation speed
remains relative stable. The degree of the compensation is adjustable but care has to be taken at
overcompensation (tendency to swinging, increase of the rotation speed upon load etc.)
11-7-1 permission
no
yes
no
11-7-2 measure
The slip calculated on the nominal and
synchronous rotation speed is the 100%, therefore
the right setting of the nominal rotation speed is
very important. (menu
0,00 - 100,00
0,00
%
Summary of Contents for V3D Series
Page 2: ......
Page 85: ...H I J PROGRAMMER S MANUAL V8 94 11 85 User settings Submenu Explanation Setting Unit...
Page 86: ...H I J PROGRAMMER S MANUAL V8 94 11 86 Notes...
Page 87: ......