COMPASS-EI–Manual – Chapter 7
Page
55
shows any
Permit Numbers
for which emissions are found for the selected year, and
the next shows any
Process Units
indicated by the user. The term
Process Unit
refers
to the “Plant or Process ID” data filed in the emission inventory report.
Figure 7.2
In the
upper right portion
of the screen, equipment (i.e., Source-Point) relationships
appear. Any selection by the user from either the
Permits
or
Process Units
lists will
“filter” the equipment relationships that appear in this window. If the user clicks on any
of the equipment relationships in the list, the
Emissions Report
will show emissions only
from the selected sources and points. If no equipment relationships are highlighted by the
user, the emissions for all sources and points will be displayed in the report. Equipment
relationships can be sorted alphabetically by Source or by Point by clicking on the
column headings, as noted on the
screen message
above the window.
In the
lower portion
of the screen, additional “filters” can be selected by the user,
including both criteria pollutant
Categories
(e.g., TSP, VOC, etc.) and specific
Contaminants
. A combination of categories and contaminants can be included in the filter
criteria for the same report.
There are
checkboxes
located in the middle of the screen to further refine the report
output. When checked by the user, the
Report Permitted Emissions Only
checkbox
function will suppress all emissions that do not reference a permit allowable emission
rate. When checked by the user, the
Report Emissions > 0 Only
checkbox function will
suppress all emissions for which the emission rate is 0 tons/year.
