Seite 35
8
Changing the heating plate
If the glass plate is needed for application, the heating plate has to be removed.
Change the plate as follows:
•
Make sure that the adjustable start stop (1) and the drawing unit (23) are
positioned in the very back of the device and that the clamping device (5) is
released.
•
Lift the weight (7) and hinge it into the top position (6) of the holding device (8).
•
Carefully lift the heating plate at the front edge and pull it out of the apparatus.
•
Carefully place the glass plate into the holder with the required side facing up.
Use the printing blanket when working with a wire-bar applicator or profile rod,
the glass surface when working with a gap applicator.
