3
6
Front panel
The following indicators and controls are available on the front panel:
1 MENU – Selects MENU mode and confirms a given preset name.
2 BACK – Moves backward through menu layers in MENU mode.
3 MUTE – Mutes corresponding channel as indicated.
4 SIG – Illuminates green when signal is present. Illuminates red
when signal is clipping (pre input mixer)
5 POWER – Indicates STANDBY (red)
6 LIM (limit) – Illuminates when the amplifier limits the
signal. Limiting is engaged when the channel:
•
Reaches the selected voltage limit
•
Rail voltage sags below the selected threshold (both LEDs
flash rapidly for 1.5 sec)
•
Maximum current output reached
•
Mains voltage cannot maintain full rail voltage
1
2
3
4
5
6
7
8
7 ADJUST/SET (Rotary Encoder) – Rotation moves through the menu
and adjusts the currently selected parameter when in setup mode.
Pressing down on the knob selects a given parameter or advances
further into the menu.
In operating mode, rotation of the ADJUST/SET encoder adjusts
output gain (outputs ganged).
8 BACKLIT DISPLAY
In operating mode, the display shows the following values and
status indicators:
•
Level – Horizontal VU meters for each channel
•
Device name and Preset name
In setup mode, the display shows currently selected menu locations
and parameters.
For more information on DSP setup procedures,
please refer to the Operation Manual.
DSP presets
Default configuration
PRESET 1, is suited for use with a stereo program into full-
range loudspeakers and provides a full-range signal with no
EQ, crossover or limiting.
The signal routing and parameter settings are:
Analog 1 routed to Ch. 1
Analog 2 routed to Ch. 2
AES 1&2 routed to Chs. 1 & 2
AES3 to analog failover is OFF
Mode: Stereo
Input levels: 0 dB
Input EQ: Flat
Output levels: 0 dB
Output mute: Muted
Output EQ: Flat
Delay: Off
Crossover: Off
DA05 & DA06 Presets
Locate your Procella speaker model and preferred EQ setting in the
attached DSP Pre-Set List. Use the front panel controls to select the
appropriate Preset on your DA05 or DA06 (see Selecting a Procella Preset
below). Connect your Procella loudspeakers to the amplifier outputs
according to the matching listings in the output channel columns.
Selecting a Procella Preset
- Push the MENU button
- Push the ADJUST/SET knob
- Push the ADJUST/SET knob again
- Turn the ADJUST/SET knob to the desired Preset
- Push the ADJUST/SET knob
- Turn the ADJUST/SET knob to select YES
- Push the ADJUST/SET knob
Verify that the display shows the correct Preset.
- Unmute the channels
For use with Procella loudspeakers, the DA05 and DA06
have programmed DSP settings to provide EQ and
crossovers for all models. No further DSP configuration is
needed for immediate use.
