7
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
6
Visit
www.probrite.com/install
for installation video tutorials and product support
Installation (continued)
3
Preparing for mounting the fixture
C
AA
CC
D
D
NOTE:
The fixture comes with the wire cover
plate (C) already installed on the fixture
arm(D).
4
Mounting the fixture
Installation (continued)
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
☐
Feed supply wires through the arm (D)
☐
Attach the fixture to the wall using the
three hex head bolts (AA) and the flat
washer (CC).
Wall Mount
Wall Mount
Wall Mount
Extension Arm Mount
☐
Remove the wire cover plate (C) from
the arm (D) of the fixture by loosening
the screws.
☐
Mark and pre-drill the three holes on
the desired location of the mounting
surface.
☐
Remove the wire cover plate (C) from
the arm (D) of the fixture by loosening
the screws.
NOTE:
Use any other suitable bolts or fasteners
as applicable to your mounting surface.
☐
If necessary, strip 3/8" of insulation
from junction box or fixture (A) wires
(fig 1).
☐
Connect fixture black wire to house
black wire, the (+) line, and fixture
white wire to house white wire, the (-)
common by twisting the exposed wires
together and using the wire nuts (BB).
Ensure no loose wires.
☐
Connect house ground wire to the
green fixture ground wire, by twisting
the exposed wires together and using
the wire nuts (BB).
IMPORTANT INFORMATION:
Extension Arm
(ARM24-SLV) is available and sold separately.
If you need to purchase the extension arm
please contact your retail store.
Installation instructions for the extension arm
are available in the instructions sheet provided
in the extension arm package.
☐
Secure the extension arm to the light
fixture arm (D) using the included arm
mounting bracket (EE) and the screws
removed earlier, until the bracket
pushes firmly against the arm mount.
Extension Arm Mount
Extension Arm Mount
X3
X3
C
D
FF
5
Making the electrical
connections
(fig 1).
☐
Place rubber grommet (FF) into the
hole of the wire cover plate before
threading wires through.
☐
Thread the wires through the hole in
the wire cover plate (C) before making
wiring connections (fig 1).
Wall Mount
Wall and Extension Arm Mount
TIP:
Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.
TIP:
After marking and predrilling the three
mounting holes, partially screw the bottom
hex bolts with washer and place the fixture's
two bottom mounting groves onto the bottom
bolts, then insert the top bolt, and tighten all
bolts to firmly secure fixture to surface.
EE
D
