Control Check
IMPORTANT:
Perform a control check at the beginning
of each boating session, after repair or after installing
new batteries.
1. Power ON the transmitter and the boat.
Do not
install the boat canopy.
2. Place the boat securely on the boat stand.
3. Test the steering: Turn the transmitter steering
wheel to the left and to the right to check for
proper control movement of the steering nozzle in
response to your transmitter input.
4. Test the throttle: Apply minimal throttle and
check that the motor and flywheel are rotating
counterclockwise.
5. If everything appears to be operating correctly,
prepare to operate the boat in the water.
Battery Pack Installation
1. Loosen the 4 screws located at each corner
of the canopy.
2. Remove the canopy from the hull starting
with the 2 rear screws. Ensure that the 4
screws have disengaged from their bases
before lifting the canopy carefully.
To secure the battery, use either the included
self adhesive foam pad or hook and loop tape
(DYNK0300). We recommend hook and loop
tape when running your boat in rough water.
3. Install the battery in the battery tray using the
hook and look straps.
4. Connect the battery pack to the EC3™
connector on the ESC.
2.4GHZ DIGITAL
RADIO SYSTEM
1. Remove the canopy from the hull.
2. Install the receiver antenna in the antenna tube.
3. Install the fully charged battery in the compartment
and secure it with the hook and loop straps.
4. Power on the transmitter. Ensure the throttle is not
reversed and the throttle trim is neutral.
5. Connect the battery to the ESC.
6. Keep the throttle at neutral and power on the ESC
by pushing and holding the power switch for 2
seconds.
• Once armed, the ESC will beep and the LED will
flash, indicating the number of battery cells it has
detected.
• 1 short beep will sound and the LED will turn
solid when the ESC is ready to run.
NOTICE:
Pressing and holding the ESC
SET
button for
3 seconds allows you to change the battery chemistry
from LiPo to NiMH. Refer to
Electronic Speed
Control (ESC) Programing
for more information.
7. Install the canopy on the hull.
Getting Started
2
2
2
5
6
4
1
7
2 seconds
3
5
EN
23-INCH READY-TO-RUN JET BOAT
