Electronic Speed Control (ESC) Programming
Step 1: Enter Program Mode
1. Power on the transmitter and set the throttle to full.
2. Connect the battery pack to the ESC. After 2
seconds, the ESC beeps twice.
3. Wait 5 seconds and the ESC emits a musical tone.
Step 2: Select Programmable Item
The ESC emits four groups of beeps in a loop.
Move the throttle to neutral within 3 seconds of the
tone matching the item you want to select.
Beep
Running Mode
Beep Beep
LiPo Cells
Beep Beep Beep
LVC Threshold
Beep Beep Beep Beep
Timing
Step 3: Set Item Value
After selecting a programmable item, you will hear
several tones in a loop.
4. Move the throttle to full to select the value
matching the tone. The ESC emits an alternating
tone to indicate selection.
5. Keep the throttle in full to return to Step 2 and
continue item selection. Move the throttle to the
neutral within 2 seconds to exit the Program Mode.
STEP 4: Exit Program Mode
1. In Step 3, after hearing the alternating tone, move
the throttle to neutral within 2 seconds. –or–
2. Disconnect the battery pack from the ESC.
ESC Programming Procedure
Programming can be accomplished using the Dynamite® LED Program Card (DYNS3005, sold separately) or via the
transmitter. Please refer to your DYNM3870 manual for transmitter programming instructions.
Programmable Items
B
BB
BBB
BBBB
Beep—
Beep—B
Beep—BB
Beep—BBB
1 short
beep
2 short
beeps
3 short
beeps
4 short
beeps
1 long
beep
1 long
1 short
1 long
2 short
1 long
3 short
1 Running Mode
Forward
Only
Forward/
Reverse
2 LiPo Cells
Auto-
Calculate
2S
3S
4S
3 LVC Threshold
No-
protection
2.8V/Cell
3.0V/Cell
3.2V/Cell
3.4V/Cell
4 Timing
0.00°
3.75°
7.50°
11.25°
15.00°
18.75°
22.50°
26.25°
= default
Changing the Battery Chemistry
1. Power on the ESC. By default, the ESC is programed
for LiPo battery chemistry.
The ESC status light flashes green and emits a tone,
indicating LiPo mode, when you power on the ESC.
2. Press and hold the SET button for 3–5 seconds, then
release it. The ESC status LED flashes.
3. Press and hold the SET button again for 5–7 seconds,
then release it. The ESC status LED changes color
and flashes red for 7–10 seconds.
4. The ESC status light goes solid and the ESC emits a
tone indicating NiMH mode.
The ESC is now armed and ready to use.
5. Repeat these steps to change the battery chemistry
back to LiPo mode.
Green ESC status
indicator light
LiPo battery chemistry
Red ESC status
indicator light
NiMH battery chemistry
WARNING:
Operating the ESC with LiPo
chemistry in NiMH mode will permanently
damage the LiPo battery.
11
EN
23-INCH READY-TO-RUN JET BOAT
