7
EN
Volere 22
getting Started
1. Power on the transmitter.
2. Connect the battery.
3. Power on the ESC switch
mounted by the steering servo
under the rear deck hatch.
4. Test the transmitter’s control of
the boat (out of water) as shown.
5. Launch the boat into the water
and start driving. If the boat
does not go straight, adjust
the steering trim dial on the
transmitter.
1
2
3
4
5
Binding
The included receiver and transmitter are bound at
the factory. It is not likely that you will need to re-bind
the receiver. However, you must re-bind when you desire
to operate this receiver using another Pro Boat 2.4GHz
transmitter or setting the failsafe.
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code of a
single specific transmitter. The included transmitter and
receiver are bound at the factory. If you need to rebind,
follow the instructions below.
1. Power off the transmitter and ESC (electronic speed
control).
2. Connect a fully charged battery pack to the ESC.
3. Power on the ESC. The RED LED on the ESC flashes.
4. Press the bind button of the receiver.
The RED LED on the ESC flashes rapidly.
5. Power on the transmitter.
6. The RED LED on the ESC turns solid when
the radio system is bound.
NOTICE:
Do not attempt to bind the transmitter and
receiver if there are other compatible transmitters in bind
mode within 400 feet. Doing so may result in unexpected
binding.
failsafe
In the unlikely event that the radio link is lost during use,
the receiver will drive the servos to their preprogrammed
failsafe positions (normally no throttle and straight
steering). If the receiver is powered on before powering
on the transmitter, the receiver will enter failsafe mode,
driving the servos to their preset failsafe positions. When
the transmitter is powered on, normal control is resumed.
Failsafe servo positions are set during binding.
