Impulse 31
3
Specifications
length
31 in (787mm)
Beam
9 in (229mm)
Motor
A3630-1800Kv Brushless
ESC
Programmable 80Amp
Brushless with Reverse;
Li-Po/Ni-MH switchable
Water
Cooling
Yes
Transmitter
Spektrum™ DX2E
2-Channel 2.4GHz Marine
Receiver
Spektrum MR200
Battery
Requirements
(
2) 7.4V 30C+
Li-Po with EC3™
connectors or (2)
7.2V Ni-MH with
EC3 connectors
Hull Material
Fiberglass
Composite
Hull Type
Deep-V
Steering System
Offset with
Breakaway Rudder
Drive System
Direct drive
flexshaft
4 AA batteries (sold separately) are
required to operate the transmitter.
Recommended Tools and Materials
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 7mm
• Phillips screwdriver: #1
• Hex wrench: 2.5mm, 3mm
• Clear tape (PRB0102)
• Pro Boat
®
Marine Grease and Gun (PRB0100)
• (2) 7.4V 5200mAh Li-Po batteries (DYNP4000EC)
or (2) Speedpack™ 4500mAh Ni-MH batteries
(DYN1080EC)
• Passport™ AC/DC Li-Po battery charger
(DYN4066) or Prophet™ Sport
AC/DC Peak Ni-MH battery charger
(DYN4056)
product Inspection
Carefully remove the boat and radio transmitter from
the box. Inspect the boat for damage. If you find
damage is present, please contact the hobby
shop where you purchased your boat.
Contents
Introduction
Pro Boat® RC models look as good as they perform. Our boats, which include everything from scale sailboats to
fully licensed powerboats, exceed expectations and provide years of radio control fun and excitement. Whether your
passion leads you towards the pure serenity of sailing or the all-out speed of a Deep-V, Pro Boat models fit your taste,
budget and lifestyle. You can count on us to be available any time you need help—the brand is backed by Horizon
Hobby, the world’s largest distributor of hobby-grade RC products. The Pro Boat brand will help you turn your boating
passion into a reality, whether you’re new to the hobby or an old pro.
Please read this manual for operation and maintenance instructions.
Register your boat online at www.proboatmodels.com.
Assembling the Boat Stand
1. Attach the side stand pieces to the end pieces as
shown.
2. Use medium CA or epoxy adhesive to secure the side
stand pieces to the ends.
3. Allow the adhesive to dry before placing your boat on
the stand.
