5
EN
Antenna Tube Installation
1. Carefully feed the end of the receiver antenna
through the grommet inside the hull.
2. Pull the antenna wire out of the grommet
towards the outside of the boat, then slide the
antenna through the antenna tube.
3. Insert the tube into the grommet, then fit the cap
onto the tube.
4. Apply clear tape to the antenna, grommet and hull
of the boat to keep the antenna from moving.
The outer end of the antenna must be installed above
the waterline of the boat to get the best reception
of your transmitter's signal.
Decal Application
Transmitter Battery Installation
This transmitter requires 4 AA batteries.
1. Remove the battery cover from
the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
Ensure the boat hull is clean. Lift a decal from
the sheet and carefully apply it to the boat
hull for the color scheme you desire.
Battery Charger
1. Connect the battery pack to the charger.
2. Connect the charger to an AC power source.
3. Allow the battery pack to charge for 12 hours.
CAUTION:
If at any time during the charge
process the battery pack(s) becomes hot to the touch,
unplug the battery immediately and discontinue the
charge process.
Impulse 17 • Miss GEICO 17
1
6
3
2
7
8
4 5
1
2
6
3
(opposite 2)
7
4
5
(opposite 4)
8
(opposite 7)
