background image

INSTRUCTION MANUAL

3

EN

General Precautions

•  Read the 

WET CONDITIONS MAINTENANCE

 procedures 

and make sure that you have all the tools you will need to 

properly maintain your boat.

•  Not all batteries can be used in wet conditions. Consult the 

battery manufacturer before use. Caution should be taken 

when using Li-Po batteries in wet conditions.

•  Most transmitters are not water-resistant. Consult your 

transmitter’s manual or the manufacturer before operation.

•  Never operate your transmitter or boat when lightning is 

present.

•  Salt water is very conductive and highly corrosive. If you 

choose to run your boat in salt water, immediately rinse 

the boat in fresh water after each use. Operating your boat 

in salt water is at the sole discretion of the modeler.

Wet Conditions Maintenance

•  Drain any water that has collected in the hull by removing 

the drain plug or canopy and tilting the boat in the 

appropriate direction to drain the water.

CAUTION: 

Always keep hands, fingers, tools and any 

loose or hanging objects away from rotating parts.

•  Remove the battery pack(s) and dry the contacts. If you 

have an air compressor or a can of compressed air, blow 

out any water that may be inside the recessed connector 

housings.

•  Dry and lubricate parts after every 30 minutes of 

operation or if the boat becomes submerged.

NOTICE: 

Never use a pressure washer to clean your boat.

•  Use an air compressor or a can of compressed air to dry 

the boat and help remove any water that may have gotten 

into small crevices or corners.

•  Spray the bearings, fasteners and other metal parts with  

a water-displacing light oil or lubricant. 

•  Let the boat air dry before you store it. Water (and oil) 

may continue to drip for a few hours. 

Specifications

Length

 

42.75 in (1086mm)

Beam

 

15.25 in (387mm)

Transmitter

  DX3 SMART DSMR 3 CH (SPMR2340)

Receiver

 

SR6110AT 6CH AVC/Telemetry  

 (SPMSR6110AT)

Hull Material

 Polycarbonate

Motor

 

Spektrum 4685 4 pole BK Marine Motor  

 1350Kv (PRB282088)

ESC

 

Firma 160A SMART Brushless Marine ESC  

 (SPMXSE1160M)

Servo

 

18KG WP 1/5th Scale (SPMS904)

Batteries 

Transmitter: 4 AA batteries

  

Boat: (2) 14.8V 5000mAh 4S 100C SMART  

 

LiPo, Hardcase, IC5 (SPMX50004S100H5)  

 

(sold separately)

Table of Contents

Safety Precautions and Warnings ..............................................2

Water-Resistant Boat with Waterproof Electronics ...................2

General Precautions ..................................................................3

Wet Conditions Maintenance ....................................................3

Specifications ............................................................................3

Box Contents .............................................................................4

Recommended Tools and Materials ..........................................4

Battery and Charger ..................................................................4

Installing the Battery Pack .........................................................4

Antenna Tube Installation...........................................................5

Transmitter Functions ................................................................5

Transmitter Battery Installation ..................................................5

Low Voltage Cutoff (LVC) ...........................................................6

Getting Started ..........................................................................6

Control Check ............................................................................6

Testing Your Boat in the Water ..................................................7

Boating Tips ...............................................................................7

When You Are Finished .............................................................7

After Boating and Maintenance .................................................8

Binding ....................................................................................8

Failsafe ....................................................................................8

ESC and Transmitter Calibration ..............................................9

Programming with the SMART Programmer Box ..................9

Motor Care ............................................................................ 10

Water Cooling System .......................................................... 10

Rudder Service ..................................................................... 10

Propeller Service ................................................................... 10

Prop Angle Adjustment ......................................................... 11

Drivetrain Lubrication ............................................................ 11

Troubleshooting Guide .............................................................12

Limited Warranty .....................................................................13

Warranty and Service Contact Information .............................14

FCC and Canada Compliance Information ...............................14

IC Information ..........................................................................14

Compliance Information for the European Union ....................15

Replacement Parts ..................................................................55

Recommended Parts ...............................................................55

Optional Parts ..........................................................................55

Product Inspection

Carefully remove the boat and radio transmitter from the box. 

Inspect the boat for damage. If your product is damaged, 

please contact the hobby shop where you purchased your 

boat, or contact Product Support. Refer to the Warranty and 

Service Contact Information section for more info.

15.25 in 

(387mm

)

42.75 in (1086mm)

Summary of Contents for BLACK JACK PRB08043


















Reviews: