Parts Required
Plywood boat stand pieces (4)
Tools and Adhesives Needed
CA or epoxy
q
1. Attach the side boat stand pieces by
interlocking them into the end pieces as shown.
q
2. Secure the interlocking boat stand with
medium thick CA or epoxy. Make certain you
allow the CA or epoxy to fully cure before
placing the boat on the stand.
Parts Required
Turn Fin
3mm hex screws (2)
Tools and Adhesives Needed
3mm hex driver
Blue threadlock
q
1. Locate the included turn fin. This will be
attached to the right sponson. Any attempt to
turn the boat left may cause the boat to flip,
especially if this is done in a tight diameter and
at high speeds.
q
2. Place the Formula Hydro on the completed
boat stand once the glue has fully cured.
q
3. Locate the turn fin and the included 3mm
hex screws (2) to secure the turn fin.
q
4. Carefully place a few drops of blue threadlock
on the threads of both hex screws. This will help
to keep the screws secured to the blind nuts
within the sponson.
q
5. Carefully attach the turn fin onto the right
sponson as shown and tighten the hex screws
with a 3mm hex driver.
Section 1: Building the Boat Stand
Section 2: Attaching the Turn Fin
Additional Required Items
Suggested Field Equipment and Supplies
Contents
Although the Formula Hydro comes fully assembled and ready for action, you will need a few additional
items in order to run your boat. You will need the following:
Zenoah
®
2-Cycle Oil (ZEN20001)
CA or epoxy glue
Fuel container
Threadlock
Fuel Pump (HAN155)
12 AA alkaline batteries (8 for the transmitter and
4 for the receiver)
Gasoline (87 or higher Octane), ethanol-free
In addition to the items needed to run the Formula Hydro, we recommend that you carry the following
in your field box:
Flex Shaft Lubrication (PRB0100, PRB0101)
Engine Tuning Screwdriver (DYN2775)
Clean towels
Extra Propellers (PRB0153)
2mm hex wrench
2.5mm hex wrench
4mm hex wrench
#1 Phillips
Small crescent wrench
Wax
Screw-locking compound
• Assembled 1/8 scale Formula Hydro RTR
• JR
®
XR3i radio transmitter
• Boat stand
• Rudder
