PRO+AQUA
Regenerating Instructions Without the WS-P-REG-KIT Kit:
1. Disconnect hoses and lay the unit on its side to drain water out, then
stand upright.
2. Remove the head of unit by turning counterclockwise and pour 4 lbs
of table salt directly into the unit.
3. Replace the head of the unit after salt has been added.
4. Let the unit stand for 40-50 minutes and agitate/shake every 10
minutes.
5. Connect your incoming hose to the “OUT” port on the unit. Connect
an additional hose to the “IN” port on the unit or place the unit on
a driveway if a hose is not available, insure the unit is upright and
leveled. This water contains high amounts of salt,
do not drain on
grass, flowers or trees
.
6. Turn water on slowly until only a pencil size stream is flowing from
the unit for 10-15 minutes, then turn the flow all the way on for 1-2
minute.
7. Once the unit has no salt water coming out, your unit is ready for
use!
1. Remove pre-filter if installed. Fill the WS-P-REG-KIT housing with 3 - 4
lbs (2 boxes) of Standard Table Salt and close clockwise. Insure to
clean salt from o-ring for a secure seal.
2. Connect the incoming water line to the “IN” port on the WS-P-REG-
KIT housing.
3. Connect one end of the Brine Hose to the “OUT” port of the WS-P-
REG-KIT housing.
4. Connect the other end of the brine hose to the “OUT” port of the
WS-P-16 unit. Connection should be on the “OUT” to “OUT” ports.
Tips
• Always regenerate before storing.
• Never let the unit freeze or dry out
• Divide 16,000 by your local water hardness to
determine gallons between regenerations.
• Replacement Resin Part #: MED-CAT-025/2
IN
OUT
CLOSE
CLOCKWISE
TABLE
SAL
T
WATER SUPPLY
REGENERATION KIT
PART#: WS-P-REG-KIT
IN
OUT
IN
PORT
BRINE
WATER
OUT
PORT
BRINE
HOSE
OUT
IN
BRINE WATER
WATER
SUPPLY
5. Stand Regen Unit on floor.
6. Turn water on slowly until only a pencil size stream is slowly flowing
from the unit for 20-30 minutes. This water contains high amounts of
salt,
do not drain on grass, flowers or trees
.
7. After 20-30 minutes, turn water on all the way for an aditional 10
minutes.
8. Turn off water and disconnect the incoming water line from the
Regeneration Kit and connect it directly to the “OUT” port of the WS-
P-16 unit then, turn the flow all the way on for 1-2 minute.
9. Once the unit has no salt water coming out, your unit is ready for
use!
10. Rinse the WS-P-REG-KIT unit to remove remaining salt and place the
pre-filter back in housing. The WS-P-REG-KIT can now be used as a
pre-filter.
Regenerating Instructions Using the WS-P-REG-KIT Kit (Sold Separately)