PRO+AQUA
WS-P-16 Guide: Getting Started
This portable water softener comes with new resin and is ready for use as soon as backwashing is completed.
Connecting the unit
1. Connect your incoming water hose to the “IN” port on the unit. (F. 4)
2. Connect a garden hose to the “Out” port on the unit. (F. 5)
3. Connect the other end of the hose to your “IN” port on your recreational vehicle. (F. 6)
4. If installing this unit for travel, ensure that the unit is secured to your recreational vehicle to avoid damage to the unit and
to the inside of your recreational vehicle. Securing the unit with any strap, is recommended.
5. The unit must be installed upright - never install the unit on its side.
6. Complete. Your system is now ready to use.
Pre-Flush
1. Connect your incoming water hose to the “OUT” port on the unit. Use the supplied female fitting if needed. (F. 1)
2. Connect an additional garden hose to the “IN” port on the unit and run it to a drain, driveway or grass area. (Optional:
if a garden hose is not available, place the unit on a flat surface or grass with area to release water).
Insure the unit is
upright and leveled
. (F. 2)
3. Turn the water on and flush the unit for 5 minutes, until the water flows clear. During your first use/wash, you might see
some color in your water. This is normal as the resin is new and will release particles on initial first flush. (F. 3)
4. Complete. You can now connect the unit.
WATER SUPPLY
ADAPTER
OUT
WATER SUPPLY
OUT
IN
OUT
IN
TO DRAIN
WATER SUPPLY
TO RV /
BOAT
OUT
IN
OUT
IN
WATER SUPPLY
(OPTIONAL)
PRE-FILTER /
REGENERATION KIT
PART#: WS-P-REG-KIT
TO RV / BOAT
OUT
CITY WATER
& TANK FILL
IN
F. 1
F. 4
F. 2
F. 5
F. 3
F. 6
