PROAIM DRIVE WIRELESS FOLLOW FOCUS 3
ASSEMBLING OF PROAIM DRIVE WIRELESS FOLLOW FOCUS
Controller power switch & receiver power
switch:
Controller power light is on for 2 seconds,
then off; red power light and green signal
light of the receiver are always on.
NOTE: To set frequency, press FREQ button
the light starts to cycle through colors. Stop
on preferred color. Repeat for each unit,
matching the colors. Verify DATA light is solid
green.
Frequency: 433-434 MHz (US 900MHz)
Memory keys use methods:
Adjust the focus wheel or dial to the
desired focus point and press the
memory button 1 for 3 seconds; if the
indicator light on the button is on and red
signal is blink for a while, it indicates the
success of this focus memory the move to
the next focus memory. At the same
time, press memory key 2,3 and 4, to
respectively record the focus.
Applicable occasions:
Wireless follow focus can completely zoom widely in steadicam movement lens and the or-
bital motion lens.
Note:
It may be insensitive in operation, because the battery voltage is too low. Please replace the
battery timely.
Infrared shutters are divided into canon and Nikon. Tell the customer service staff about your
camera model when purchase.
Insert the Anteena onto the Controller and
Receptor.
