3. If you want to return the package back out of the laminator, click direction in the position "REV"
(reverse).
4. After completion of the work, slide the network in the "OFF"
Notes:
• listed in the table are average values and may vary Depending on the quality of the used film.
• The thickness of the film using should be chosen depending on the thickness of laminating
document for documents using a thick the film. For laminating photographs and film thickness
should be chosen 100mkm and above. For laminating photos, printed on matte textured paper
(canvas, satin) should be set to the temperature 10 "200C above.
• If the document is poorly laminated (sheets of film are not stuck or poorly stuck to each other,
the film does not become transparent), then increase the temperature
• If the output under the film turned out to be small air bubbles or film turned undulating surface,
then reduce heat.
• Hot lamination can be started only after the green
LED "READY". In the lamination process, he may flash as the unit equipped with a thermostat
that controls heating of the shaft during operation.
• The inner parts of the laminator are covered with a special compound, why, particularly, during
the first time, you may receive a characteristic smell.
• Try not to touch the inner surface of the film
• Do not laminate the coins and other objects of the thick
• To extend the life of the laminator before turning off to leave the unit turned on at the lowest
temperature controller (80 ° C) or in a cold lamination for 3 "5 minutes (for laminators PRO "MS
A3, PRO MS" A3 +, PRO MS "A2).
1. Set the temperature to 120-140 degrees. And wait indicator lights up when ready "READY"
2. Place the foil is not color side on a sheet with the image or text the top. At the top of the foil
also put any piece of paper so that it fully covers it. Place the bag in the front pocket of the
laminator.
3. Remove the top sheet and gently not glued to a sheet of foil with image or text.
Cold lamination *
1. Set the temperature at the position of "COLD". Make sure that switch the direction of lamination
was in position "FWD" (forward).
5
Film Thickness (mm)
Temperature ° C
2х60
95-105
2х80
105-115
2х100
115-125
2х125
125-130
2х150
130-135
2х175
135-145
2х250
145-160
Temperature dependence of the thickness of the film used
lamination and laminate package again.
