Instruction
• Before operating the laminator should be familiar with this instruction and comply with the
requirements.
• When removing the unit from its packaging must remove the tape (if available), fixing the power
cord.
• Be very careful to matches to the set temperature and the thickness used the film as otherwise
may lead to melting of the film.
• Do not place anything on top cover of the laminator and not touch the hot roll laminator and hot
parts of the body.
• Do not place the laminator at the following locations:
• on an inclined plane
• Damp location
• Where the equipment is subjected to vibration
• In a dusty room
• Where it is exposed to direct sunlight or direct exposure lighting
• Do not operate the laminator with wet hands
• Take precautions against falling into the laminator liquid foreign objects, insects
• Take precautions against accidental fall of the laminator
• Keep children away from laminator
• Do not leave the laminator power on unattended the operator.
• Before changing the location of the laminator cleaning or turn it off from the network and Wait
until it cools down (at least 1 hour).
• Do not operate the laminator if it is open the top cover is damaged body or the power cord
• To avoid accidents, do not expose hair, neckties, clothing and jewelry in the laminator.
• If you pull clothing, hair, and so on. Etc. a laminating machine, quickly move power switch to
"OFF" position or switch directions lamination in position "REV" or unplug the power cord.
• Do not open or attempt to repair the laminator yourself.
• Do not place in the output tray laminator nothing but paper documents
• Use a laminator at ambient temperature "of 18 to 25 ° C.
• If you experience the presence of strangers (tinny) sound may be bad an upper cover unit.
Replace the cover correctly. Attention! In continuous operation laminator more than 2 hours is
recommended to de at break for 20 minutes. Do not use the laminator for continuous operation
more than 4 hours. Improper operation of the laminator may overheat 4 parts of the laminator and
failure. Remember! For the possible consequences and problems resulting from incorrect
operation of the laminator manufacturer is not liable. Hot lamination. 1. Turn on the laminator,
turning the switch network in position "ON", while indicator lights up "POWER". In accordance
with the film thickness (See Table 1) Set the thermostat to the desired position (for models PRO
MS "A2, A3, A3 +, you must also set the type of lamination (hot or cold) through switch 6). Make
sure that the switch the direction of lamination was in position "FWD" (forward). After the green
LED "READY" (ready), the laminator is ready. 2. Insert laminiruemy sheet and place the package
in the output tray laminator exactly, glued edge first (see figure), the laminator will automatically
captures the packet and lamination. Laminations pack size smaller than the format laminator
need to install the package in output tray, aligning the center of the front edge of the package and
the middle of the receiver tray.
4
