10
Troubleshooting
Fault
Power LED doesn’t light up
No video is displayed on
the monitor
Solutions
●
Check the battery mounted is available.
●
Check the power plugs of TX and RX are properly inserted
into a functioning power outlet.
●
Make sure the power sources connected to TX and RX are
functional
●
Make sure TX and RX are working at the same
frequency
●
Verify that the proper cable has been selected and
installed between the TX input and your SDI output.
●
Make sure your camera connected with TX has been
powered.
●
On your monitor side, select the SDI/HDMI source
you connected to RX.
●
Check your video resolution with SDI input from your
device is 1080P, 1080i, 720P, 576i or 480i.
●
Ensure transmission distance is not over 200m (LOS).
●
When all the above are checked and there’s still no
video, change to another frequency point and
restart the set.
Poor picture quality or
intermittent video play
●
Check your video resolution with SDI input from your
device is 1080P, 1080i, 720P, 576i or 480i.
●
Make sure cable connection is correct.
●
Ensure transmission distance is not over 200m (LOS)
and there’s no interference between TX and RX.
●
Check if there’s any high power intercom system
within 2 meters
●
Make sure there’s no large block between the set
(e.g. walls)
●
Check if there are large metal objects moving
between TX and RX (e.g. trucks)
●
Check if there is any device/equipment to block or
interfere signals nearby (e.g. high power
equipments, signal tower)
●
Make sure the set is not placed on a metal shelf or
similar place with metal
●
Try restart the set or change the set to another
frequency point and restart the set.
No audio
●
Check your monitor or other equipment’s volume is
properly set and not in “MUTE” mode.
●
Make sure cable connection is correct.
●
Check your video resolution with SDI input from your
device is 1080P, 1080i, 720P, 576i or 480i.
●
Shutdown and restart the set.
Summary of Contents for XW-HDU03
Page 1: ...XW HDU03 XW HDU03 ...
Page 13: ......
