Pro-Weld CD-512, Operation Manual

Page: 11 / 32

CD -5 1 2
PRO WEL D
This technique, when equipment is set up properly,
is simple and easily mastered. The same power sup-
ply is capable of welding many different sizes and
materials of fasteners. If you require assistance in
selecting the proper accessories, contact our cus-
tomer service department or your field representa-
tive.
7.0 POWER REQUIREMENTS
110 VOLT OPERATION
110 volt AC 60 H: 25 amp service
Internal Fusing : BUSS ABC 25 amps;
slow blow;
P/N 120-0025
Integral 9 foot power cord
IF EXTENSION REQUIRED
Cable Length 110 Volt
12’ #16/3
25’ #16/3
30’ #14/3
50 #12/3
8.0 SYSTEM SPECIFICATIONS
Weight:
64 Lbs.
Size:
8 1/2” H x 13 1/4” W x 20” D
21.6 cm H x 33.7 cm W x 50.8 cm D
Chassis:
16 Ga. Steel (Painted International Orange)
Panel Controls:
Power
Voltage Control
Weldable Materials:
Steel, Stainless steel, Aluminum, Copper,
Brass, Zinc coated, Galvanized
Weldable Stud Diameter:
12 Ga. Through 7/16” Weld Base
(Max W.B. Dia. For AL=5/16” {1/4” thread})
Weld Rate:
24 per minute 5/16”
Weld Voltage:
45-185 VDC
Capacitance:
84,000 uF nominal Low Range
168,000 uF nominal High Range
Weld Mode:
Contact
Polarity:
Straight or Reverse
Power Required:
110 Volt AC 60 Hz 25 Amp
Internal Fusing:
BUSS ABC 25 Amp Slo-Blow(110V)
3AG 1 Amp 250 volt (2 on PC board)
STANDARD GUN & CABLE SPECIFICATIONS
WELD GUN-LIGHT DUTY PRECISION
CD CONTACT
Part Number:
300-0200 HD B Collet Gun
300-0201 HD Taper Tip Gun
Weight:
2 lbs. (not including cable)
( lbs. (including 25 ft. #4 weld cable & 16-4
SOW control cable)
Size:
6 1/2” x 5 3/4” x 2”
Weldable Stud Diameter:
12 Ga. Through 7/16” W.B. Dia.
Material:
High strength, impact resistant, glass fiber re-
inforced polycarbonate
Integral Gun Cable Length:
25 feet – #1 AWG
Connectors:
Male Camlok / 2 Pin Hubbell Male
Cables
Ground Cable:
(2) #1 x 15’ (P/N: 125-0101)
PAGE 3