![background image](http://html.mh-extra.com/html/pro-point/8844185/8844185_manual_1607382011.webp)
V1.0
Long Barrel Air Hammer
8844185
Visit www.princessauto.com for more information
11
5. Pull on the chisel to confirm it is locked into place.
6. Test the chisel placement by running the tool at no load for
approximately 30 seconds. Point the chisel in a safe direction in
case it is ejected from the air hammer.
OPERATION
PRESSURE DROP
Apply the air consumption and pressure rate numbers to the tool’s air
inlet, not the compressor’s outlet. Calculate the pressure drop for your
air supply set-up and increase the compressor outlet pressure to
compensate. Make sure you do not exceed the maximum pressure for
any part of your air supply system.
Installing a pressure gauge at the tool inlet is the best way to measure
the air pressure and adjust the compressor’s output.
TOOL OPERATION
1. Ensure the regulator switch is in the neutral or OFF position.
2. Connect the tool to the air source.
3. Turn the compressor regulator to the desired air pressure (see
Specifications).
4. Firmly grip the air hammer with both hands and place the chisel
against the workpiece.
5. Squeeze the trigger (C) and slowly move along the workpiece. Do
not force the air hammer; let the tool do the work.
6. If the chisel is not performing well, turn off the tool and examine the
chisel to see if it is dull. Replace with a sharp chisel. Remember
that sharp tools are safer than ones that have become dull.
7. Once finished, disconnect the tool from its air source and
discharge any residual air in the tool before storing it.
8. Remove the chisel and the spring retainer after each use. Clean the
air hammer, retainer and chisels to make sure there is no
accumulated dust or debris remaining on the tool. Reinstall the
retainer back onto the air hammer before storage.