![background image](http://html1.mh-extra.com/html/pro-point/8835910/8835910_instructions-manual_1607432014.webp)
8835910
Victor Style Heavy Duty Cutting and Welding Kit
V1.0
14
For technical questions call 1-800-665-8685
2. Screw the red acetylene fuel regulator (M) into the acetylene
cylinder (P) and make sure it is secure.
3. Screw the green oxygen regulator (J) into the oxygen cylinder (K)
and make sure it is secure.
4. Screw a flashback arrestor (L) into each regulator’s low pressure
outlet. Make sure the arrows on the arrestor match the gas flow
direction when installing.
4.1 Only install flashback arrestors designed for the type of gas in
the cylinder.
5. Screw the red acetylene fuel supply hose (O) to the flashback
arrestor on the acetylene cylinder (P).
6. Screw the green oxygen supply hose (N) to the oxygen
cylinder (K).
7. Install hose check valves (D) onto the inlets of the torch body (B) or
cutting blowpipe.
8. Screw one of the three swaged nozzles (A), the heating nozzle or
the cutting tip onto the welding body (H) based on the welding
task. Tighten the coupling nut to secure.
9. Connect each supply hose to the correct check valve. Re-confirm
the oxygen and acetylene fuel hoses are connected to the correct
inlets.
10. Confirm all valves are closed.
CHECK FOR GAS LEAKS
Check for gas leakage after each time the welding unit is set up for
welding and at regular intervals.
1. Connect the regulator and gas hose assembly and then tighten all
connectors and clamps.
2. Slowly open regulator valve on the acetylene fuel cylinder until the
hose is pressurized.
3. Close the cylinder valve and pay attention to the needle indicator
on the regulator’s pressure gauges. If the needle drops away
towards zero, there is a gas leak.