8740144
MAGNETIC DRILL
V1.0
20
For technical questions call 1-800-665-8685
OVERLOAD PROTECTION
The drill has an overload protection feature that will activate if the
drill is drawing too much power and is overheating. Once
activated, turn the tool off, unplug it and let cool for several
minutes. When ready to resume, plug the tool back into the
power outlet, press the reset button (M) and proceed through the
normal start up procedure.
The tool should be allowed to cool after several hours of
continuous use, regardless if the overload protection feature
was activated or not.
RELEASING THE SLUG
1.
The drill will eject a metal slug upon completion of the cut.
DO NOT operate the machine if the slug remains in the
cutter bit, as it may cause injury if flung out.
2.
Place the drill on a flat surface, switch on the magnet to lock
it into place. Gently bring the cutter bit down to make
contact with the surface. This will usually straighten and
release the stuck slug.
CARE & MAINTENANCE
1. Maintain tools with care. Keep cutting tools sharp and
clean. Properly maintained tools, with sharp cutting edges
are less likely to bind and are easier to control.
2.
Check for misalignment or binding of moving parts,
breakage of parts, and any other condition that may affect
the tools operation. If damaged, have the tool serviced
before using. Many accidents are caused by poorly
maintained tools.
3. Follow instructions for lubricating and changing accessories.
4. Use only accessories that are recommended by the
manufacturer for your model. Accessories that may be
suitable for one tool, may become hazardous when used on
another tool.