V1.0
6 in. Composite Orbital Air Palm Sander
8630790
CLEANING
Keep the tool clean. Wipe the tool with a clean cloth and periodically
blow out all areas with compressed air. If compressed air is not
available, use a brush to remove dust from all areas. Do not use harsh
chemicals or solvents to clean the tool. These chemicals could
seriously damage the plastic housing.
Periodically, remove the backing pad (30), by sliding the pad wrench
(29) between the backing pad (30) and the pad cover (9). Engage
the nut on the shaft to lock it in place, and spin the backing pad (30)
off. Clean out the inner workings of the sander inside the housing (1.1)
with a vacuum or a brush. Replace the backing pad (30) securely.
MAINTENANCE SCHEDULE
Daily Air Supply Maintenance: Every day, perform maintenance on
the air supply according to the component manufacturer’s
instructions. If a lubricator is used, the oil level needs to be
maintained and the moisture filter must be regularly drained.
Performing routine maintenance on the air supply will allow the tool
to operate more safely and will also reduce wear on the tool.
Weekly
Clean the muffler filter (if one is attached). Remove the
muffler cap (24), remove the filter and wash in warm water. Allow to
dry completely prior to replacement.
LUBRICATION
Only use air tool oil to lubricate the tool. Other lubricants may not
be suitable and could damage the tool or cause a malfunction
during use.
1.
It is very important that the tool be properly lubricated. Without
proper lubrication, the tool will not work properly and parts will
wear prematurely. Manually dropping a drop or two of air tool oil
once a day into the tool's male connector is better than using an
automatic in-line lubricator, which should only be required when
there are multiple users of the same tool.
Visit www.princessauto.com for more information
13
