V 4.0
15,000 to 25,000 BTU Convection Propane Heater
8619488
4. Push in and hold the automatic control valve button (see figure 2). Push
and release the piezo ignitor button. Keep pushing the piezo ignitor button
until the burner lights. Hold the control knob down for a maximum of 10
seconds while attempting ignition. If the heater does not light, release the
control knob and wait 30 seconds and then repeat this step.
NOTICE: Keep hands and face away from the outlet (around the top of the
shell) of the heater while attempting to start the heater.
5. After ignition, hold the control knob down for approximately 30 seconds.
This activates the automatic control system.
6. If the burner will not light after repeated tries, do not attempt to repair the
heater. Have the heater repaired at the nearest service centre.
7. When the burner remains lit, you can turn the heater regulator knob
clockwise to the desired heat setting. If the burner goes out, turn off the
gas. Check the fuel supply. If the fuel supply is OK, restart the heater.
TO STOP THE HEATER
1. Tightly close the propane supply valve on the propane tank(s) by turning
clockwise. Wait 15 minutes for the heater to cool down before handling
the heater.
2. Always remove the gas supply hose from the heater and the propane tank
after each use.
TO RESTART THE HEATER
1. Wait 5 minutes after stopping the heater.
2. Repeat the steps in the section To Start The Heater.
CARE & MAINTENANCE
1. Always remove the propane supply tank from the heater when not in use.
2. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
3. Before each use, check the heater for leaks. Never use an open flame to check
for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles
forming show a leak. Correct all leaks at once.
Visit www.princessauto.com for more information
11
