INTRODUCTION
CONGRATULATIONS
The Marquee-Lite
™
PLUS
is the finest retrofit messaging center available on the market
today. It is available in two sizes, a 6 foot (ML3225) or 8 foot (ML4225) unit. The Marquee-
Lite
™
Plus (ML+) is designed for ease of use, ease of installation, and years of trouble free
service.
These displays are designed to fit in either an 8 or 6 foot cabinet. In some cases you may
install the unit(s) in a larger cabinet, but suitable filler panels will need to be fabricated. Your
ML+ is designed to slide into a standard cabinet, with a 2” flange or less. The finish size is
71.875” and 95.875” respectively. This gives plenty of room to fit in the appropriate
cabinet. If your display does not take up the whole cabinet space, a divider bar and filler
panel must be fabricated. This is usually a sign face made of polycarbonate, and is included
with most retrofit kits. Please contact your local sign fabricator if you do not have this
solution.
OVERHEATING DANGER: The cabinet MUST be equipped with a proper
ventilation system. Without proper ventilation, the sign will overheat,
cause condensation on the components and/or plexi or cause other
damage. This damage will not be covered under the warranty.
The ML+ sign can already dissipate heat from its own casing, but not the
cabinet enclosure that will hold the sign. Vents on the sides toward the top
end of the cabinet enclosure should be installed to allow air to escape.
Make sure proper vent installation techniques are followed to prevent
water from entering through the vents.
READING INSTRUCTIONS
Retain manual for future reference.
Follow all warnings and instructions indicated in this manual including those marked
on the product.
BEFORE INSTALLATION
Do not allow AC power to be connected inadvertently during installation.
BEFORE OPERATION
Confirm all connections are correct and secure by reviewing manual before power up.
DURING OPERATION
Do not make modifications while sign is in operation.
MAINTENANCE
Do not open, modify or disassemble any part of the unit. This will void warranty and
may result in electrical shock and serious injury.
To maintain warranty, the unit must be installed in a cabinet that protects the back of
the unit from water. Your unit is not designed to repel running water from the back.
Exposure to running water on the back will void the warranty.
