Check the operations of your trim tabs before getting underway. To operate the trim tabs locate the trim tab
rocker switches on the console. Press both switches forward and hold them down. This will engage both trim
tabs and will ensure they are working properly while in the full down position.
The switch on the port side operates the starboard trim tab. The switch on the starboard side operates the port
trim tab. To check each trim tab individually, press one of the trim tab rocker switches forward and check to see if
the opposite trim tab goes down. For example if the starboard trim tab switch is being pressed down, the port trim
tab should be going down. Repeat the same process for the opposite side.
While underway and in open water, clear of other boaters, depress the top half of the switches in half-second
increments to achieve the desired degree of trim. To correct a starboard list, depress the top half of the port
switch in small increments until the list is corrected. To avoid over trim, allow a few seconds between tab
adjustments to allow the boat to respond. If you over trim, simply give the over trimmed tab an adjustment in the
opposite direction. Push the top half of both rocker switches in half-second increments to trim the bow down.
Warning: Trim tabs can cause a dramatic change in the attitude and heading of your boat.
Adjust them in small increments when in open water and clear of any obstructions.
Trim Tab Indicators (Optional)
This indicator switch may be added when trim tabs are factory installed. The
waterproof indicator and switch lights up to let you know exactly where your trim
tabs are.
Windlass with Rode and Chain (Optional)
The windlass anchor system is located on the bow. It is an electric hands free anchor system that allows the
driver to raise or lower the anchor while staying at the helm. The windlass comes with 200 feet of ½ inch line and
6 feet of ¼ inch rode.
12
Summary of Contents for 2009 Grand Sport 29
Page 2: ...ii...
