20
•
Set the portable toilet on its front side so the cap on the holding tank is in a vertical position.
Remove the cap and add SeaLand brand holding tank deodorant following the instructions on the
deodorant container. Replace the cap firmly.
•
Before using: Set the portable toilet in the upright position and remove the cap located on the
right, rear side of the fresh water tank. Fill with fresh water just below the neck of the fresh water
inlet. Depress the bellows pump to add water to the bowl.
•
After using: To flush, open the slide valve by pulling out the handle and press the bellows pump
one or more times. After flushing, close the slide valve by pushing handle.
Before operating the porta-potti head system, refer to the manual in your owner's packet supplied by the
porta-potti manufacturer for specific operating instructions.
Doors, Storage and Hatches
Head Door
The poly head door is equipped with a locking latch. To open the door, just pull the latch and pull the door open.
To close the door, slide the door back into the track of the doorframe and push the door closed until it snaps in
place. The latch will engage itself. The door should never remain open when you are underway or when
conditions might cause a passenger to lose their balance and accidentally fall through the doorway.
The locking latch comes with a set of two numbered keys. We recommend that you make note of the key number
and keep it in a safe place. In the event that you need to replace the keys, this will allow you to replace just the
keys and not the entire lock assembly. See the Service and Care section of this manual for cleaning
recommendations.
Storage
Your boat has plenty of storage areas for your tackle and/or gear:
•
Glove box with lock installed in the dash
•
Storage compartment in the floor forward of the console seat
•
Casting deck storage box (wet/dry storage compartment)
•
Rope locker storage at the bow (wet/dry storage compartment)
•
Drink holders – Stainless steel
Rod Holder Storage
In addition to the rod holders installed on the optional rigid T-Top frame, the following rod holder storage is
available:
•
Rod Holders with Inserts - One pair of stainless steel rod holders with PVC inserts to protect your
rods. As an option, an additional pair of rod holders can be installed.
•
Rod Racks - A pair of rod racks is installed in the port and starboard freeboard of the aft cockpit.
Combined, they can accommodate up to 6 fishing rods.
•
Vertical Rod Holders (Optional) – Four vertical rod holders are included when you select the
optional rigid T-top and frame.
Hatches and Latches
To open the hatches just lift the handle of the latch from the recessed area of the hatch, twist it and lift the hatch
open. Make sure that all hatches are closed and secured before you get underway.
In addition to the deck hatches, there are round access pies installed on the boat that provide access to
components. The following photo identifies the locations of the components that can be accessed via the deck
hatches and access pies.
Summary of Contents for 2008 20 Sport
Page 2: ...ii...
