© Audio Trade GmbH · Pro-Ject Tuner Box · Revision 1.3.08/1.5.08
3
Using the Pro-Ject Tuner Box
Tuner Box
Tuning
87.90
MANUAL
Push
ON/OFF
Tune
Level
MHz
Turning on/off
Press the
Tuning
to switch the tuner on. Press and hold the same button for a few seconds to switch the tuner off.
If the Tuner Box is connected to the remote switch-on facility of a Pro-Ject pre amplifier, then choosing input 1
at the pre amplifier will switch the tuner on. Selecting a different input will switch the tuner off.
After being switched on the display will briefly show the Pro-Ject logo before changing to the regular display.
Display
A
Signal strength meter
B
Stereo reception
F
Mono reception
C
Fine tuning meter
D
Tuning mode. The
Tuning
button toggles between the tuning modes
E
Tuned frequency
87.90
MANUAL
A
B
C
D
E
Manual program search
Press the Tuning button repeatedly until the display shows
MANUAL
. By rotating the Tuning button the reception
frequency will be increased or decreased in 50kHz steps. The tuner is correctly adjusted for a stereo broadcast
when
A
the largest number of bars are shown (signal strength meter) and
B
two loudspeaker symbols are shown (
F
one loudspeaker symbol shows mono reception)
C
the vertical bar is centred in the fine tuning display
Automatic program search
Press the Tuning button repeatedly until the display shows
AUTO
. Rotating the Tuning button clockwise starts
the automatic frequency scan upwards, anticlockwise starts it downwards. The maximum signal strength will
be adjusted automatically for each program found.
Program selection from memory
Press the Tuning button repeatedly until the display shows
MEMORY
. Rotating the Tuning button clockwise
will select the program with the next memory position up the list, anticlockwise will select the program with
the next memory position down the list. The program’s memory position is shown to the right of
MEMORY
in the display.
Saving a program in the memory list
The Pro-Ject Tuner Box can store up to eight programs in memory. Tune to the frequency of the program to
be stored. Press the Tuning button twice in rapid succession. The display will show
STORE
. Rotating the
Tuning button clockwise will select the next memory position up the list, anticlockwise will select the next
memory position down the list. Press once on the tuning button to store the program at that position. The
display shows
STORED
.
Saving a program to a particular memory position overwrites any program already stored at that
position. The memory retains its contents through a power off/on cycle.
