© Pro-Ject Audio Systems · Pro-Ject Phono Box E BT · Revision 2019.03.26
3
Alternatively the built-in Bluetooth transmitter allows to relay signal from inputs (Phono or Line) to any Bluetooth
receivers such as Pro-Ject MaiA or Bluetooth Box E (S) or directly to Bluetooth speakers or headphones.
Bluetooth transmitter connects to the receiver with strongest signal automatically.
If you want to connect it to a Bluetooth Box E (S) it is important to connect the Phono Box E BT to the power
supply first. Otherwise it is possible, that the boxes are not able to connect. The boxes connect automatically.
If the connection is successful, you will hear a sound. Now you are able to use it.
Output signal is always present on both outputs (analogue and Bluetooth).
Mains power connection
Connect the low voltage plug from the power supply to the Power 18V socket of the phono amplifier before
connecting the power supply to the mains.
Technical specifications Pro-Ject Phono Box E BT
Gain, MM:
34dB
SNR:
74dB
THD+N:
0,02% @ 1kHz
RIAA-equalisation curve accuracy:
20Hz - 20kHz / max. 0,5dB
Bluetooth transmitter:
Version 2.1 (Class II), A2DP 2.1 support
Bluetooth range:
10 meters in direct visibility between source and receiver
Outboard power supply:
18V/500mA DC, suitable for your country's mains supply
Power consumption:
200mA DC
Dimensions W x H x D (D with sockets): 120 x 32 x 100 (106) mm
Weight:
280g without power supply
Potential incorrect use and fault conditions
No signal on one or both channels:
No connection between signal source and phono amplifier or amplifier. This could be due to a faulty
.
plug, broken wire or solder joint or simply loose plug/socket connection.
Strong hum:
No earth connection from cartridge or arm, or arm cable to phono amplifier, or earth loop.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the unit
be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons; release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
